Sanav GC-101 Installationshandbuch PDF herunterladen (Seite 28)

8) Installing/Starting the OpenDMTP, TK10x, and Aspicore DCS Modules

This section describes how to start and stop the "gtsdmtp", "tk10x", and "aspicore" device communication server

(DCS) modules, however these instructions are also applicable to other device communication servers which may also

be installed or implemented.

More information on the OpenDMTP project may be found at the link "http://www.opendmtp.org". Support for

OpenDMTP compliant devices is included in OpenGTS with the "gtsdmtp" device communication server (DCS).

The "tk10x" DCS module supports most common TK102/TK103 protocol compliant devices (Note: some manufacturers

producing a TK102/TK103 device may be using their own custom protocol variant that is not compatible with the

common TK102/TK103 protocol).

Aspicore provides client phone software for tracking various Nokia, Samsung, and Sony Ericsson phones. The

Aspicore DCS within the OpenGTS package is designed to work with the TCP or UDP data transport method which can

be configured within the Aspicore client phone application. For more information on their supported phones, and to

obtain their client software, vistit their website at "http://www.aspicore.com/en/tuotteet_tracker.asp?tab=2&sub=1".

8.1) Configuring the "dcservers.xml" File

The file "dcservers.xml" contains a few configurable properties that effect the execution of the OpenDMTP

("gtsdmtp") and Aspicore ("aspicore") servers. Most of the properties values should be left as their default value,

but the following properties values can be set to those appropriate to your operating environment:

OpenDMTP:

• tcpPort="31000"

• udpPort="31000"

TK10X:

• tcpPort="31272"

• udpPort="31272"

Aspicore:

• tcpPort="31265"

• udpPort="31265"

These ports are specified on the "ListenPorts" tag for their respective "DCServer", and are the default ports on

which these servers listen for incoming connections from the remote devices. You can change this port by changing the

value on this tag attribute. You can also indicate multiple ports by specifying them with comma separators. (ie.

'tcpPort="31000,31100"').

8.2) Starting the Device Communication Server

The "gtsdmtp", "tk10x", or "aspicore" server can be started as follows:

/zzz> cd $GTS_HOME

/usr/local/OpenGTS_1.2.3> bin/runserver.sh -s server

Where "server" should be replaced with the specific name of the server to start (ie. "gtsdmtp", "tk10x", or

"aspicore").

OpenGTS Configuration and Installation Manual Page 28 of 60

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 59 60

Keine Kommentare

Sanav GC-101 Installationshandbuch Seite 28